Alexor WT4901 User Manual download pdf (Page 2)

DSC Alexor Page 2 of 7

Arming & Disarming the System

Arming (Turning on)

Close all sensors (i.e. close doors and windows). The Ready indicator should be on. Arm

the system using either of the methods below.

Arming Method #1: Enter your access code. If exit door is opened and closed, system will

arm in AWAY mode. If exit doors is not opened and closed, system will arm in STAY mode.

Arming Method #2: Press STAY button or AWAY button until keypad beeps and arming

process begins.

If armed in the AWAY mode, you now have 30 seconds to leave the premises. To cancel the

arming sequence, enter your access code.

Note: If motion detectors have not been installed on the alarm system, there is no difference

in arming in STAY or AWAY mode.

Disarming (Turning off)

Enter your access code to disarm anytime the system is armed. The keypad will beep if you

walk through the entry door. Enter your code within 45 seconds to avoid an alarm condition.

Quick Exit

If the system is armed and you need to exit, use the Quick Exit function to avoid disarming

and rearming the system.

1. Press and hold the EXIT button for 2 seconds. You now have 2 minutes to leave the

premises. When the door is closed again, the remaining exit time is cancelled.

Before Calling…

♦ Is the keypad beeping? Press *2. This will silence the beeping and let you

know where the trouble is.

♦ Is there a flashing triangle on the keypad? Press *2 for status information.

♦ Is siren going off? ENTER CODE to stop siren.

1 2 3 4 5 6 7

No comments

Alexor WT4901 User Manual Page 2